Jump to content
Ultimaker Community of 3D Printing Experts

under extrusion with new feeder


Recommended Posts

Posted · under extrusion with new feeder

I recently printed this feeder and attached it to my ultimaker 2

https://www.youmagine.com/designs/alternative-um2-feeder-version-two

Ever since, my printer has been under extruding.

I've tried loosening and tightening the tension on the feeder and i've tried cleaning out the print head a dozen times and all i've managed to accomplish is getting a hotend covered in burnt ABS which needs to be scraped off.

I don't know if the tension is too loose or tight and i can't seem to get the atomic method of clearing the printer to work with abs properly so i've resorted to using a paper clip to try and scrape the inside and push the junk out.

PLEASE HELP!

 

  • Link to post
    Share on other sites
    Posted · under extrusion with new feeder

    Tension needs to be high enough so that the knurled wheel bites into the plastic, which should leave nice precise series of toothmarks. The plastic should not be squeezed so hard that it deforms to an ellipse shape, as the feeder will then be losing a lot of torque just getting the filament through the narrow gap in feeder.

    The whole feeder chain is actually quite a simple mechanism. If you check for binding at every step along the way, e.g. possible binding on the spool, excessive tension in the feeder, excessive friction in the tube (tightly wound filament), dirty nozzle etc, it should be possible to pinpoint where the problems are.

    Also consider a temperature test and that the filament is good quality of the correct diameter.

     

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...