Jump to content
Ultimaker Community of 3D Printing Experts

Display and Controller Freezes


slugore
 Share

Recommended Posts

Posted · Display and Controller Freezes

Our office just recently received our Ultimaker 2 and I am the lucky fella that gets to play with the Ultimaker2.

I immediately upgraded the firmware and believe that I am on the most recent, if there hasn't been a new release in the last 2 or three weeks. (As of April 24, 2015)

On more than one occasion, the display screen and controller has frozen. In fact, it has just done it 2 times in a matter of minutes. First when I was advancing material getting ready to do a print. I was using the move material function and dialled too quickly causing the familiar "tocking" noise of too quickly advancing the filament when the screen froze... no controls. I reset by switching off and on again.

Next, I started a print and had just adjusted the build plate temperature after the first layer was done and was in the middle of adjusting the nozzle temp back down to 210 when the screen and control froze again.

The print is proceeding normally an I am assuming that it will be fine until then.

I am wondering if anyone else has experienced regular crashes of the display screen and controller. I have tried searching the new forums but am totally befuddled by the format and search.

  • Link to post
    Share on other sites

    Posted (edited) · Display and Controller Freezes

    It may be worth repeating the firmware update, maybe something went wrong ?

    also a "factory reset" is worth a try

    if that does not fix it then I would log an urgent support ticket - this is definitely not normal behaviour

    good luck

    Edited by Guest
  • Link to post
    Share on other sites

    Posted · Display and Controller Freezes

    Excellent, I will give it a try after I print the important pieces for work that are on the bed right now.

     

    It may be worth repeating the firmware update, maybe something went wrong ?

    also a "factory reset" is worth a try

    if that does not fix it then I would log an urgent support ticket - this is definitely not normal behaviour

    good luck

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share

    • Our picks

      • New here? Get ahead with a free onboarding course
        Hi,
         
        Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
        Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.   
        They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access. 
        Ready? Register your product here in just 60 seconds.
          • Like
        • 11 replies
    ×
    ×
    • Create New...