Jump to content
Ultimaker Community of 3D Printing Experts
kpk

For Ultimaker 2 extended the filament guide is not able to attach in available space given below

Recommended Posts

Hi and Welcome to the community,

Are you talking about the small guide that goes at the back left side of the printer?

Normally you should put it at 90° and rotate it. You may need to apply some force to put it in place.

But it's not a mandatory item, personnaly i don't use it at all because to me it adds some unnecessary friction to the filament and doesn't really help to guide the filament better.

  • Like 1

Share this post


Link to post
Share on other sites

I would like to back @Didierklein. Without dual extrusion it isn't really necessary.

Sometimes it is a bit of a tight fit, but you might as well could leave it out.

When you have found the answer you are looking for, could you select a 'Best Answer'? This will help future readers with similar questions to find the answer that helped you faster.

Thank you!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Our picks

    • Ultimaker Cura | a new interface
      We're not only trying to always make Ultimaker Cura better with the usual new features and improvements we build, but we're also trying to make it more pleasant to operate. The interface was the focus for the upcoming release, from which we would already like to present you the first glance. 
        • Like
      • 122 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!