Jump to content
Ultimaker Community of 3D Printing Experts

Is there anyone here from Turkey that can give me samples of 20/100 Micron print


Recommended Posts

Posted · Is there anyone here from Turkey that can give me samples of 20/100 Micron print

Title speaks for itself. I am in Bursa/Turkey, is there anyone from Turkey that can send me two prints that shows difference of 20/100 micron print?

  • Link to post
    Share on other sites
    Posted (edited) · Is there anyone here from Turkey that can give me samples of 20/100 Micron print

    The answer could again be 3Dhubs, on the client side this time.

    There is a section of 3DHubs dedicated to provide exactly what you ask, Ultimaker samples:

    https://www.3dhubs.com/ultimaker

    So you could go there and either select one of the listed models, or upload your own, and then look for the printer closer to you.

    Of course someone from Turkey with an Ultimaker could see your message here and reply directly here, wish you best luck.

    20 micron print is nominally possible, but actually unrealistic. You could print at this resolution but:

    - the print would take FOREVER

    - the quality could be deceiving, especially on hoverhangs

    In practice, for an ultra quality print 0.06 will be the lower you will get.

    For one, if you asked me to print something at 0.02 I would refuse. And chances are that a 0.02 micron oder will be refused by many many other people with an Ultimaker and some printing experience.

    Edited by Guest
  • Link to post
    Share on other sites
    Posted · Is there anyone here from Turkey that can give me samples of 20/100 Micron print

    20 micron print is nominally possible, but actually unrealistic. You could print at this resolution but:

    - the print would take FOREVER

    - the quality could be deceiving, especially on hoverhangs

    In practice, for an ultra quality print 0.06 will be the lower you will get.

    For one, if you asked me to print something at 0.02 I would refuse. And chances are that a 0.02 micron oder will be refused by many many other people with an Ultimaker and some printing experience.

    Thanks for this part. I didn't know 0.6 was preferable.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    ×
    ×
    • Create New...