Jump to content
chazah

X Axis Belts too tight ?

Recommended Posts

Posted (edited) · X Axis Belts too tight ?

So my Ultimaker v1  has been sitting in the basement for the last few months and now the X axis is really stiff ..

I tried to print something small and the print failed due to slipping

I have oiled the rods but yet no avail

: S

Edited by Guest

Share this post


Link to post
Share on other sites
Posted · X Axis Belts too tight ?

You can always replace the belts if they are bad, but I don't think slipping would be caused by the belts being too tight. Especially after sitting for a few months.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!