Hi folks
The build plate of my brand new Ultimaker S5 undergoes active leveling before each print. It results in either of my 2 extruders over or under extruding. Is there a way i can disable this active levelling process before each print, as i personally prefer manual leveling. The prints doesnt look that cool compared to the price i paid for this printer. Hope there is a solution to this.
Okay so here's how to disable active leveling on S3 or S5. But keep in mind that
1) This is not an approved operation by Ultimaker. If you are going to call customer service about something, put it back the way it was or install the latest firmware first.
2) You shouldn't do it if you are a beginner regarding unix/linux.
3) You can "brick" your machine if you make a typo (like delete a semicolon or comma). Unbricking requires a 4GB uSD card and an email to your reseller and sp