A lot of bumps/pits on my prints.
I printed a little box that didn't come out as nice as I had hoped for:
So I thought that maybe this was all related to the TMC2209 stepper motor drivers I had installed so I decided to switch them back. But before that I printed the cylinder on the right (2209) and after switching to the stock drivers I printed the cylinder (same gcode file was used) on the left. All the bumps/pits are identical on both prints so much so that if this was a court case, there would be a conviction:
When I first moved to Cura 4.7 I noticed a fall in print quality. Curves and arcs were very blobby, and I didn't know what had happened.
About the time that 4.8 came out I read a blurb someplace that explained that the Creality printers weren't capable of handling the fine resolution settings contained within the Cura machine definitions for the Creality printers. The main problem was with the Mesh Fixes | Maximum Resolution of 0.05. An adjustment to 0.4 made a huge difference in the qual
