[Request] Show current layer in the display
Some layers needs to be supervised when printing. It would be a great help if the Ultimaker Display could show the current layer it's printing.
It would fit nicley on the firs row. Example
Printing layer: 167
UM3_abc
25min 19s
A small new years gift for the tech savvy out there, with an Ultimaker S5 or S3.
A patch with layer count/total below the time remaining.
NOTE: this is not coming from Ultimaker officially, this could brick/break your printer, no guarantee is given on these steps or this file, while this is likely to work with a bunch of versions I've only tested with newer than the recent release.
And if there are any complaint I'll of-course remove this immediately.
Steps to e
