Help: Upgraded TinkerGnome firmware, now I get X or Y switch broken
Hi folks,
I have run into a strange new issue and I am not sure how to resolve it. Some help would be much appreciated.
I have, up until yesterday, been running @Tinkergnome 16.07 on my UM2+. Today, I upgrades to the stock version in Cura 2.1.3, then upgraded again to Tinkergnome 16.08.1.
Now, homing the head does not work correctly and I get the error message "X or Y switch broken". Using Expert funtions -> Move axis, I can move the Y and Z axes, but X does not move.
Here is the weir
Update:
Ultimaker has moved some settings in EEPROM to different addresses recently...
and that overwrites the "tinker" settings that are already stored there...
So... if you switch back and forth between the standard and the tinker variant... a factory reset is mandatory from now on... (at least for the + models)
