Ultimaker 3 cannot connect to WiFi
Hey guys!
I am quite new to the Ultimaker and the community. A few years ago I had a different (selfbuilt) 3D printer, but things got very frustrating, so I paused until I bought myself an Ultimaker 3, two days ago. Yesterday I did the whole setup and everything went well and worked perfectly fine. In the evening I did a Firmware Update and shut the printer down afterwards.
After shutting everything down for the night, I tried to print today and noticed, that the printer was not showing in
This is an old problem but I think I've cracked it... My WiFi was working flawlessly with 5.3.0, but in preparing my unit for sale, I did a factory reset. In setting up I suffered from the WiFi issues mentioned in this thread. It was not clear as an incorrect password would de rejected, but with a correct password things went askew. I attached a LAN cable and did some digging, but found nothing.
Then I thought back how I set up the printer and considered the 2+ connected printer beh