enemenemeck
-
Posts
2 -
Joined
-
Last visited
Never
Content Type
Forums
Events
3D Prints
Posts posted by enemenemeck
-
-
Hi,
day two after finishing my ultimaker. wow!
I realy like the quality of my first test prints.
The black spacers between bottom and controller are to short, right?
The controller touches the wood with its backpack board. Its higher then the black spacers long.
Am i right or do i misplaced something?
Please have a look at:
https://www.icloud.com/photostream/#A3G4TcsmdjgFe
Test print pictures:
- Robot was my first print, factor 0.5 sized
- Belt tension plates printed and mounted
- snowflake has some strings
- 20mm @0.5mm wall square looks quite perfect to me
settings cura default, retraction ON at 220 degrees
One bearing hole was lasered to big, it moves in all directions.
(I did not sand anything during the building process.)
Nearly all x&y shafts could be shifted some 0,x mm if i push them manualy. Is that fine or should they be tightly fixed?
Hints and comments are welcome.
Thx, Andreas
Distance bottom plate to controller board
in Coffee corner
Posted
Thanks for your reply.
You are absolutely right, at this point i did not read the wiki pages carfully enough and got fooled by the pictures shown black spacers there.
After using the mentioned white ones it fits fine.
So far i realized no problems caused by the one loose bearing or the axially space. All walls printed pretty straight and after playing around with different start/main temperatures most of the other small problems are solved.