miro-laserdesign
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by miro-laserdesign
-
-
Habe den Ultimaker Original Plus zusammengebaut. Die gedruckten Teile sind etwas kleiner als das 3D-Modell. Beim Ultimaker 2 stimmt die Größe ziehmlich genau. Suche im Internet eine Anleitung für das Benutzermenü des Ultimakers Original Plus. Unter "Control - Motion" im Benutzermenü denke ich, kann ich die Werte ändern, um am Ende mein Modell mit den richtigen Maßen gedruckt zu bekommen. Eine Anleitung wäre hilfreich, damit ich nicht raten muss, welche Werte geändert werden müssen. Im Internet kann ich keine ausführliche Anleitung zum Benutzermenü finden.
Ultimaker original plus eichen
in Deutsch
Posted
Wer sucht, der findet. Für alle, die es interessiert:
Motion
Acc
The standard is 3000, it allows you to adjust the acceleration speed.
Vxy Jerk
Vxy Jerk is the acceleration of the acceleration
Vmax x
The maximum speed in mm/s
Vmax y
The maximum speed in mm/s
Vmax Z
The maximum speed in mm/s
Vmax E
The maximum speed in mm/s
Vtrav min
This is the minimum distance to travel
Vmin
The minimum speed in mm/s
Amax x
The speed in which the motors can accelerate.
Amax y
The speed in which the motors can accelerate.
Amax z
The speed in which the motors can accelerate.
Amax e
The speed in which the motors can accelerate.
A retract
The acceleation speed in which you allow retraction to operate
X steps-mm
The accuracy the steppers can make the motors move in.
Ysteps mm
The accuracy the steppers can make the motors move in.
Zsteps mm
The accuracy the steppers can make the motors move in.
Esteps mm
The accuracy the steppers can make the motors move in.