JohanP
-
Posts
5 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by JohanP
-
-
Slowly after 20cm, it looks to be a normal print.
I made new program with new Cura, where it will also be just 50%.
What have I changed and where do I fix it?
-
-
-
Is there support for running the same material in both the nozzles, the printer switches nozzle when the material runs out in the first.
It would save a lot of attention and material for me.
Bond Tech Versus the New Designed Um2+ Feeder
in Third party products & modifications
Posted
Most likely the "Flow %" in the material settings (on the printer), at least you can check that.
Was this the first time that you've installed the tinker firmware? I don't know, how many settings you have customized, but if you switched back and forth between standard and tinker firmware recently, a factory reset would be the best choice (the stored settings in EEPROM are not longer compatible for the "+" models).
Thank you, you were right, it was the flow was changed.
And I've done a factory reset.
Back on the track