UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
We have not had this experience with warping of ColorFabb XT. To look for warping we use a 6cm x 6cm x 0.8cm (w x d x h ) model (warping is more likely to occur on wide low height models) and we have ended up with a very flat model.
This is not to say that warping will not effect particular models or print environments but it was quite straight forward to achieve this effect.
We cannot comment on the eSun PTEG so we cannot compare. we can only say this warping issue is not our experience.
The printing settings for this print are written on the file.
Curling comparison - Colorfabb XT vs Esun PETG
in Materials & profiles
Posted
We have not had this experience with warping of ColorFabb XT. To look for warping we use a 6cm x 6cm x 0.8cm (w x d x h ) model (warping is more likely to occur on wide low height models) and we have ended up with a very flat model.
This is not to say that warping will not effect particular models or print environments but it was quite straight forward to achieve this effect.
We cannot comment on the eSun PTEG so we cannot compare. we can only say this warping issue is not our experience.
The printing settings for this print are written on the file.