UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
GrabCad Print flagged my Stratasys 768 as needing a firmware update (it runs 7.1 at the moment). When I put the printer into update mode, the update utility downloads the firmware and sends it the machine. The machine validates the firmware and prompts to confirm and finish the installation by rebooting. After rebooting, the machine comes back up with the old firmware 7.1, instead of the 10.1.
Do I need to install an intermediate firmware first? If so, where can I get this intermediate firmware from?
Thank you
I did not find the right solution from the internet
References :
Firmware Update Process?
in What have you made
Posted
Hello all,
GrabCad Print flagged my Stratasys 768 as needing a firmware update (it runs 7.1 at the moment). When I put the printer into update mode, the update utility downloads the firmware and sends it the machine. The machine validates the firmware and prompts to confirm and finish the installation by rebooting. After rebooting, the machine comes back up with the old firmware 7.1, instead of the 10.1.
Do I need to install an intermediate firmware first? If so, where can I get this intermediate firmware from?
Thank you
I did not find the right solution from the internet
References :
https://www.3dprintforums.com/forum/threads/3717-Firmware-Update-Process
Company Promo Video