UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Is there any possible way to adjust raft printing temp in Cura? Cuz, while a raft is a freaking awesome tool for bed adhesion but removing it afterwards is kind of a pain. Though I'm aware that Cura has an option to lift up Z a little bit to print parts on and it works quite well but I think that may not be enough. One thing I would do in combination of z lift to get the raft to peel as easy as possible is to manually lower the temp at the final top raft layer before it starts printing part. I generally print PLA at 215 and when the it starts printing the final raft layer, I crank it down to around 200-205 and after the first layer of the part is done, I manually set it back again to 215. And that makes the raft peels off like a charm, so I just wonder whether there is an option somewhat like that, or if not, could you guys add that into Cura please? Cuz that would save a lot of time and hassles especially with parts that require really big raft.
Raft printing temperature option
in Third party products & modifications
Posted
Is there any possible way to adjust raft printing temp in Cura? Cuz, while a raft is a freaking awesome tool for bed adhesion but removing it afterwards is kind of a pain. Though I'm aware that Cura has an option to lift up Z a little bit to print parts on and it works quite well but I think that may not be enough. One thing I would do in combination of z lift to get the raft to peel as easy as possible is to manually lower the temp at the final top raft layer before it starts printing part. I generally print PLA at 215 and when the it starts printing the final raft layer, I crank it down to around 200-205 and after the first layer of the part is done, I manually set it back again to 215. And that makes the raft peels off like a charm, so I just wonder whether there is an option somewhat like that, or if not, could you guys add that into Cura please? Cuz that would save a lot of time and hassles especially with parts that require really big raft.