[UM2 and Duet3D board]

16 minutes ago, jeanmarcboulay said:

hello, i have a um2 clone (jennyprinter 3) on which mainboard is HS. i bought a duet wifi and a pt100 board. for wiring i think i am ok but i doesent understand how to use/modify z endstop to do bed levelling.... i read your posts but i don't understand...

i have to move my z endstop ? (mine is at the bottom) if yes , what is the better way to install it on top; i can't see how it is done on a "umo" ...

 

and after, to make a bed levelling, i move manually z axis, i write the value and after, where to put it to calibrate bed ? 

thanks for help

 

Hello, you don't have to move your Z-endstop, but installing a Z-sensor for leveling. The easiest, most accuracy and most economic solution is this model.

 

https://es.aliexpress.com/i/4000180840997.html

 

It is  plugged on the nozzle until the leveling map is completed. After that, remove the sensor, reboot your Duet and the printer will be calibrated. PCB board is not neccesary, just the inductive sensor. It can be managed by Duet.

 

Cheers!

[UM2 and Duet3D board]

On 4/21/2019 at 5:10 PM, ultiarjan said:

Sure, here's my system directory.

DuetSystemDirectory.zip 10.95 kB · 2 downloads

 

Thank you so much! It was very helpful!

 

Best regards

[UM2 and Duet3D board]

Hello.

 

Recently, I bought a Duet3d ethernet for my JennyPrinter3D (Ultimaker 2+ extended clone). I decided to change the original board, which was rubbish, for this one. It looks great and the webpanel is incredible. I am trying to configure the new board with reprap configurator but it is a little bit complicated. Could anyone share their parameters? It would be very helpfull.

 

@Neotko I saw your video of Duet Connection in Youtube. It was very useful (me fue muy útil y está todo muy bien explicado).

 

Regards!