UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Ultimaker U2+ bed leveling issue
in Firmware
Posted
Hi
I recently brought a second hand U2 that hadn't been used for a while.
Before using it i decided to replace all the belts as they were well past there best and upgrade it it to a U2+.
I followed the instructions for the + upgrade and updated the firmware at the very end.
now when you set up the bed to the print head it fails as it trys to home the bed with a z switch error ER05.
this happens before the bed gets to the switch but to be on the safe side i replaced it anyway.
if i try to level the bed to the heads and drop the bed rather than raise it it will then pass.
the firmware is currently at 3.3.0.
Any ideas please
Thanks Bob