kenjcain
-
Posts
3 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by kenjcain
-
-
Call off the dogs. I found the problem. Seems the part was printing was too small and the print head was running over the same area before it was set. I printed it along side of another part and it came out perfect.
Stay tuned. I will likely have other problems in the future. Thanks folks.
- 1
-
Anycubic Mega S seems to have developed some problems. Ran great right out of the box, but started to develop a severe problem printing even the simplest images.The print head appears to push around previous layers and creates a "snowbank" near the edge. The print head then keeps running into it and screwing up the whole print.The first two pics I provided are how the problem developed early and later on as well. The third photo is from an earlier job that printed just fine.I have not done anything physical to the machine except clean the nozzle, re level and clean the bed.Any ideas of how I can fix this problem would be appreciated.BTW. If it is not already obvious, I am new to this #D printing.Thanks in advance.
Looking for material.(PLA ABS etc.)
in Coffee corner
Posted
I am going through a fair amount of filaments. Anyone know of a good place to shop for material in the Durham Region (Oshawa) Ontario?