UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I am rather new here to this forum so sorry if this topic has already been covered, I picked up a roll of Priline's carbon fiber polycarbonate and i can not find an exact setting in cura for this material i just went with the generic version, of this tried adding it to cura via market place but some reason it's not quite working, i have a profile saved to run my cfpc. I am going to be diving into some functional parts for a 3d printer upgrade and wanted to get my setting better and came here to look. Priline isnt a company that cura has in their data base i guess because I tried many times to look for this brand. Any input is greatly appricated, i will continue with my saved profile and test a few others. I ran quite a few prints with this material even made a fang and mounted it to my cr10s5, it needed to be able to withstand high temps as it is fastened to the heat exchanger, has worked great just looking to improve upon my prints and looking into the slicer software.
Priline Carbon Fiber Polycarbonate
in Third party products & modifications
Posted · Edited by Dilli90
Hello everyone,
I am rather new here to this forum so sorry if this topic has already been covered, I picked up a roll of Priline's carbon fiber polycarbonate and i can not find an exact setting in cura for this material i just went with the generic version, of this tried adding it to cura via market place but some reason it's not quite working, i have a profile saved to run my cfpc. I am going to be diving into some functional parts for a 3d printer upgrade and wanted to get my setting better and came here to look. Priline isnt a company that cura has in their data base i guess because I tried many times to look for this brand. Any input is greatly appricated, i will continue with my saved profile and test a few others. I ran quite a few prints with this material even made a fang and mounted it to my cr10s5, it needed to be able to withstand high temps as it is fastened to the heat exchanger, has worked great just looking to improve upon my prints and looking into the slicer software.