UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
5.0 was working fine when I first downloaded it. Much better than the other versions in my opinion. However, my virus scanner started scanning and quarantining it. I attempted to put it in an excluded status, but it still quarantined it. I've had to turn off my active scanning in order to run it. Now having issues with 5.0+beta+01. It's acting as if it's loading the first time, and I have to add my printer's all over again. When it does finally boot up it will show my other printers. Cura is my preferred slicer, but I'm having to use another slicer until the issues are resolved.
McAffee & Cura 5.0.0-Beta+1
in UltiMaker.com
Posted
5.0 was working fine when I first downloaded it. Much better than the other versions in my opinion. However, my virus scanner started scanning and quarantining it. I attempted to put it in an excluded status, but it still quarantined it. I've had to turn off my active scanning in order to run it. Now having issues with 5.0+beta+01. It's acting as if it's loading the first time, and I have to add my printer's all over again. When it does finally boot up it will show my other printers. Cura is my preferred slicer, but I'm having to use another slicer until the issues are resolved.