[Infill showing through wall]

Thank you! changed the inside wall width and it solved my issue.

 

 

[Infill showing through wall]

I have attached the .3mf. 

 

Currently using Overture easy nylon, heat 217, speed 60mm, extrusion 99%, .6mm hot end. New hot end as of yesterday, been an issue prior. Checked nozzle and is sunk to base. Ill try heat next if you don't see anything else.

AV_EPHolder.3mf

[Infill showing through wall]

Anycubic Vyper, stock rom, no upgrades, Ultimaker Cura Slicer 5.2.1

 

Running into an issue with infill showing through walls, or walls intersecting. Below are the settings I have tried, but with no success. It is an issue with every print. Also getting some pretty bad bulging at corners, believe acceleration and jerk are to low?

.1 through .8 nozzles

line widths from .1-.85

Layer heights from .1 to .6

Infill from 5% to 100%

Wall thickness from .8mm - 4mm - Higher the wall count the worse it gets.

Infill overlap less than and more than 10%

Wall optimization on and off

Print walls before infill on and off

Different speed settings

Several different brands of PLA, ABS and Nylon.

 

I printed just a plain block which is the best print I've had in awhile, but still showing some infill. Tracks have been cleaned, wheels tightened and belts, also made 0 difference.