About This File
Came out pretty good for a first try with the Innofil PRO white.
This test print was also used to test gradual infill steps. I used 40% line infill with step height of 1.2 mm, not being sure if printer could handle laying down the denser layers with too small a step height. It turned out that 1.2 was a bit much, I am confident that .6 will work just as as fine - will test that sometime soon...
A tiny bit of stringing between the pillars and an occasional 'blob' where it started printing the outer wall, other than that I am quite pleased with this first result (just a little fine-tuning will lead to perfection - I hope 
).
I truly love the shiny surface and the 'translucent' effect on the thinner parts of the print.
If you have recommendations for improving quality, please let me know!