UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I just wanted to verify that it was still OK to connect the USB cable to the Ultimaker after the jumper has been made on V1.5.4 to power the USB on board. I suspect it's not an issue, but I wanted to make sure it was OK and that no damage could occur to connected computer or to Ultimaker. Thanks!
OK to connect USB after UltiController Jumper made?
in UltiMaker 3D printers
Posted
Hello,
I just wanted to verify that it was still OK to connect the USB cable to the Ultimaker after the jumper has been made on V1.5.4 to power the USB on board. I suspect it's not an issue, but I wanted to make sure it was OK and that no damage could occur to connected computer or to Ultimaker. Thanks!
ciao
lino