Jump to content

tbenst

Dormant
  • Content Count

    2
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. Doh - the top board was upside down. For anyone that comes across this in the future, make sure the the drilled portion faces the inside of the extruded casing.
  2. Hello, I'm buildings recently purchased Ultimaker with the V2 hotend. I am stuck at the extruded step 3.2.22-23. Although the Vowden clamp does fit in the front right hole of the milled 8A board, there is not enough room for the Bowden tube to fit in the clamp. I also tried inserting the clamp in the laser cut 8A board, and the Bowden tube also would not fit through the clamp. Should I use a dremel to widen the hole and/or thin 8A around the hole? Thanks for your help!
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!