UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Hey all,
I'm new to 3d printing in general, I've seen many references to 'width over height' setting in other slicing programs and at http://calculator.josefprusa.cz/.
Is there a setting or way to change these settings in Cura?
Thanks!
Andy