poligonaltree
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by poligonaltree
-
-
Hi all,
I am just setting up an ultimaker 3 extended in a company network and to my surprise the system cannot assign the right IP address to the printer because the MAC address can not be found in the arp table.
I check that and what it shows is this:
169.254.204.192 (incomplete) eth0inlocal
This test was using a direct connection with the printer over Ethernet. As you can see the mac address appears as (incomplete).
Is there a way to solve this problem? otherwise I would need to configure the printer with a static IP address and configure the right gateway.
UM 3 Ext- Difference between
in UltiMaker 3D printers
Posted
For Anyone reading this with the same problem in this printer the actual error comes from the two printer heads being measure not in the right order.
As you can see in the video posted by mrGokhan the first printer head to be measure is the printer head B, and then it measures the Printer head A. that means that the relative distance is in fact negative and therefore giving a non realistic values.
The solution is to manually switch the printer head B up, so it starts to measure the printer A first. Why this is happening, I am not sure.