[Ultimaker 2 Dual extrusion]

But it's getting into a state where a viable upgrade-kit becomes harder and harder. Due to all the changes they are making. They kinda lost track of the goal (upgrade for the UM2), and went beyond that (much improved hotend).

 

So Ultimaker 3 it is. Can we already place pre-orders?

But joking aside, an improved hot end with dual-extrusion would be sweet!

 

[Filament not being released in one direction]

Hi,

I've been running into the same problem with a lithoplane.

The prints starts with the diagonal. Working up and to the left, the printing continues smoothly and evenly, but when the second half needs printing (from the diagonal down to the right), the printing is very rough and occasionally manual intervention is necessary to stop the layer (last line, but the problem grows exponentially from there) from peeling off.

The bed levelling has been checked and should not be an issue.

 

[New Cura does not start on older machines]

Hi,

I have run into the same problem/error as described by Albert, and in my case installing an updated version of the graphic card driver solved the problem. Might be worth a try!

mlg

Gerhard