r0cha
-
Posts
2 -
Joined
-
Last visited
Never
Content Type
Forums
Events
3D Prints
Posts posted by r0cha
-
-
Our Ultimaker has formed a plug of PLA about 3cm above the hot end of the clear pipe. Heating the machine to try and liquify the ply of PLA didn't work and when I tried to pull out the PLA from the reel end it snapped off at the other end of the clear pipe. I now have above 5mm of PLA showing at the reel end of the pipe and non at the hot end.
I need help!
If I cut off the clear pipe above the plug of PLA will the shortened clear pipe still be usable, or will it cause other issues?
Any other suggestions much appreciated.
Photo below.
Plug of PLA in clear pipe - help!
in UltiMaker 3D printers
Posted
Thank you for your help, much appreciated. Back in action after a little surgery on the Bowden.