UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
same problem with my ultimaker 2. Unfortunately. After almost 2 hours of gently trying to remove it by heating up the nozzle at different temperatures i give it up finally.
Next question is where to go from here? Cut the sensor and replace it? I have no problem releasing the heating part.
I admit, the nozzle is a mess with burned filament but as i learn here, this is not something unusual to happen. So i agree, its a design flaw to make these parts that are easaly worn out to be so hard to replace.
Temperature sensor stuck - UM2
in UltiMaker 3D printers
Posted
Hi,
same problem with my ultimaker 2. Unfortunately. After almost 2 hours of gently trying to remove it by heating up the nozzle at different temperatures i give it up finally.
Next question is where to go from here? Cut the sensor and replace it? I have no problem releasing the heating part.
I admit, the nozzle is a mess with burned filament but as i learn here, this is not something unusual to happen. So i agree, its a design flaw to make these parts that are easaly worn out to be so hard to replace.
Herman