[Printing Settings to print Coffee Stirrer]

There's only a picture of the spoon. Not the settings.

Is this the orientation you printed in? You should definitely flip it over if so - you want the spoon facing down. This should fix a large portion of your issues. Turn off support if you have it on - you probably don't need brim either (although if the part lifts off the bed while printing, turn brim back on.

Regarding retraction:

There are 6 retraction related settings:

1) Make sure retraction is checked on basic/quality

2) In expert settings set minimum travel to 0mm or at least something small like 1mm.

3) In expert settings set "minimal extrusion..." to 0mm. I hate this setting right now.

4) In expert settings you can set "combing" on or off - it shouldn't make a huge difference for this part. Lately turning this "off" seems better in the current version of Cura but in the next version it might be best to turn it back on.

5,6) On the printer, you can control retraction there also Leave the retraction speed alone but change the retraction amount from 4.5mm to 5.5mm.

 

Hi ,

Thanks so much for replying!

I saved my settings in a Microsoft word document which can be found here.

https://www.dropbox.com/s/17h5i8bkt4y5336/Settings%20for%20Stirrer%20Print.docx

I have been tweaking the settings for more than a month, im getting nowhere close to a good print. Is it inherent of all 2.85mm 3D printing machines?

Thanks!

 

 

[Printing Settings to print Coffee Stirrer]

Hi,

Im rather new at the Ultimaker 1 and i tried a couple of settings for printing a Coffee Stirrer. This coffee stirrer has already been in production by a company but I am trying it in order for me to get better prints. However, the effect didn't turn out as well as I think as i still do not understand how the different settings work. Any kind soul out there would advise me on this? Attached is the link to the files and my settings in the Ultimaker.

Additionally, the supports are always getting in the way of a good print. Im not too sure is it my settings or the Ultimaker 1 just cant handle fine details.

https://www.dropbox.com/s/73k4k2oht17l5sl/20131217_135940.jpg