UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I've been printing with an Ultimaker original succesfully for quite some time, but a few days ago the following problem started happening:
During printing my temperature drops very slowly and the hotend switches on but temperature doesn't rise. After around 20 seconds the temperature jumps up by a huge amount, as you can see on the screenshot (sometimes even jumps above MaxTemp). Burned plastic also starts flowing out of the nozzle after the temperature jump.
The whole measuring system works perfectly when reading room temperature and when heating up.
I've searched the internet and did some troubleshooting but the problem still occurs:
Check whether thermocouple still works - Doesn't look damaged and gives good readings.
Check wiring to main board - Wiring between sensor and main board still working.
Check whether it is a software problem - Autotuned PID controller and used different slicers and controllers (Cura, Slic3r, Pronterface, RepetierHost)
Check external interference - there are some dimmers in the same circuit as the printer which could cause voltage peaks, but switching off all of those did not make a difference.
Check thermocouple amplifier board - Everything is properly connected, LED works and sensor gives good readings
This pretty much eliminates all hardware and most of the software causes. If the machine loses connection with the sensor the temperature would instantly jump to its maximum or minimum value right? (or is this filtered by the PID controller?).
My last guess would be that the problem lies in the firmware (I'm using The version of marlin that Cura installs, the display shows : 13.03 250000_single).
Floating temperature values cause overheating of hotend
in UltiMaker 3D printers
Posted
Hey Ultimaker community,
I've been printing with an Ultimaker original succesfully for quite some time, but a few days ago the following problem started happening:
During printing my temperature drops very slowly and the hotend switches on but temperature doesn't rise. After around 20 seconds the temperature jumps up by a huge amount, as you can see on the screenshot (sometimes even jumps above MaxTemp). Burned plastic also starts flowing out of the nozzle after the temperature jump.
The whole measuring system works perfectly when reading room temperature and when heating up.
http://i.imgur.com/VNY9GOT.png
http://i.imgur.com/EG1TcSj.png
I've searched the internet and did some troubleshooting but the problem still occurs:
This pretty much eliminates all hardware and most of the software causes. If the machine loses connection with the sensor the temperature would instantly jump to its maximum or minimum value right? (or is this filtered by the PID controller?).
My last guess would be that the problem lies in the firmware (I'm using The version of marlin that Cura installs, the display shows : 13.03 250000_single).
Do you have any tips/guesses?