blind-anguis
-
Posts
2 -
Joined
-
Last visited
Never
Content Type
Forums
Events
3D Prints
Posts posted by blind-anguis
-
-
Hello there!
I recently got my Ultimaker 2 and i love it, though i have a small "problem" with the surface of my prints, the surface is a but rough, only where there is a overhang (see the bad picture in the link)
https://dl.dropboxusercontent.com/u/25961194/IMG_20140826_162255.jpg
I was wondering if i can do anything about this, do i have wrong temperature? For this print i used PLA with
Layerheight: 0.02mm
Shell thickness: 0.8mm
Fill density: 15%
Speed for outer shell: 30mm/s
Temperature: ~200° C
Fanspeed: 100%
Thanks
/ Blind Anguis
Rough surface
in Coffee corner
Posted
Thank you for the answer! I will try to use thicker layerheigt, although i think 0.02 looks alot better than 0.1, at least on vertical surfaces ! Oh and is it posible to sand the surface? Or does the PLA turn white?