Jump to content

johnmclarren

Dormant
  • Content Count

    1
  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral
  1. Received my UM2 a few days ago and have been absolutely loving it. It's quiet, fast and precise. I did have a few hurdles, first I had a heat bed issue when I first turned it on requiring me to take the build plate apart where I found a loose wire for the heat bed. After that I had an issue with the extruder, I noticed filament was not coming from the tip no matter how much I ran the extruder. Turns out the gear on the rear feeder ground into the filament. I retracted it, cut it off and fed it back and it has worked perfectly since. I do have one question, I have run it over night once. I know it turns off the bed and hot end when it finishes and I have it set to turn lights off, but is it ok for it to stay on? It sounds like it keeps fans on even when not running. John
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!