[Replacement-Part Bowden Tube for UM2]

I'd consider the 15/19€ as some sort of stupidity tax. Ordered a 3.18mm labeled as compatible from ebay now. Meanwhile i jumped the risk and taped the existing bowden end to end.

So far it's halfway through the print (slow, 4 h) that was meant to be done Saturday. I do know that that is no good solution and eventually it will come off again.

 

[Replacement-Part Bowden Tube for UM2]

Thanks for all your help folks! i will see how i go from there.

 

[Replacement-Part Bowden Tube for UM2]

I cut it right in the middle :/

Thank you for your help, I got it removed now. I dont have time anymore today for it, but judgeing from sight, there is no special form to it (neither front nor end). I will try to put it back together tomorrow, maybe a shrink sleeve could help, just thinking out loud.

 

[Replacement-Part Bowden Tube for UM2]

Hello,

story:

I had some grinding issues with my feeder and the filament got stuck in it, in a weird way. I could not remove it from the outside and could for my life not find out how to pull out the tube from either side. So in a "rage fit" i cut it apart, (I know, i am not a smart man). In the end the FIlament got out.

Question:

is the replacement bowden tube from the shop: https://www.ultimaker.com/products/bowden-tube

compatible with the UM2 at all? If yes is there a manual on how to replace it properly?

Do you think as an intermediate solution, it is possible to tape the tube back together?