UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I am excited to get a new Ultimaker 2 back home. I printed 3 models so far and still doing the fine tune for the bottom layer. The bottom layer is very coarse now, but other layers are pretty good. (i am using z resolution of 0.02mm and bottom layer with 1mm)
Last night i met a problem. After i start a 40 min job, i went back to sleep, but this morning there is nothing on the plate, the LCD shows jobs done. Is the nozzle been blocked? Anyone have seen this problem before?
stop printing after printed 3 models
in UltiMaker 3D printers
Posted
Hi all,
I am excited to get a new Ultimaker 2 back home. I printed 3 models so far and still doing the fine tune for the bottom layer. The bottom layer is very coarse now, but other layers are pretty good. (i am using z resolution of 0.02mm and bottom layer with 1mm)
Last night i met a problem. After i start a 40 min job, i went back to sleep, but this morning there is nothing on the plate, the LCD shows jobs done. Is the nozzle been blocked? Anyone have seen this problem before?
Thanks,
David