UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
When I try and level the print bed on my Ultimaker2, there is a problem with front left and right of the print bed. There is a small amount of upward slop in the bed and when I slide the paper between the nozzle and the bed then remove it, the bed goes clunk, indicating that bed is being pushed down then moves back up when the paper is removed. Because of this I can't get an accurate gap with the front. Is there a way to take the slop out of the bed front??
Best procedure for leveling the bed.
in UltiMaker 3D printers
Posted
When I try and level the print bed on my Ultimaker2, there is a problem with front left and right of the print bed. There is a small amount of upward slop in the bed and when I slide the paper between the nozzle and the bed then remove it, the bed goes clunk, indicating that bed is being pushed down then moves back up when the paper is removed. Because of this I can't get an accurate gap with the front. Is there a way to take the slop out of the bed front??