[Custom heater block to fit E3D nozzle on Ultimaker 2 ("The Olsson Block")]

Great, thanks a lot for the quick answer.

[Custom heater block to fit E3D nozzle on Ultimaker 2 ("The Olsson Block")]

Hi folks,

Hope this question hasn't been asked already, sorry if it has.

I need to switch back and forth quite often between the different nozzles, and I was wondering if I could use this as an oportunity to soak the nozzles in acetone, just to make sure they are good as new when I put them back on.

I've warped my printer with plastique to keep some heat in when printing ABS, and I don't feel like taking everything off just to perform the atomic clean, so to me this would be a nice alternative...

- Would that cause any harm to the nozzle?

- Would that be usefull at all?

Thanks