Jump to content

fvilliers

Dormant
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Hi folks, Hope this question hasn't been asked already, sorry if it has. I need to switch back and forth quite often between the different nozzles, and I was wondering if I could use this as an oportunity to soak the nozzles in acetone, just to make sure they are good as new when I put them back on. I've warped my printer with plastique to keep some heat in when printing ABS, and I don't feel like taking everything off just to perform the atomic clean, so to me this would be a nice alternative... - Would that cause any harm to the nozzle? - Would that be usefull at all? Thanks
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!