azukaa

There was dust in the nozzle, we removed it and it started to work again. After that, we try to print again and the figures didn't stick at the hot bed, so we put some glue and it didn't work neither. After it, we set the bed temperature at 70°C, and it started to have good adhesion but the nozzle suddenly stopped printing. The nozzle temperature was at 250°C. Flow at 100%, print velocity at 50 and travel velocity at 150 and Fan at 127%. What could it be? It's pretty hard working with ABS and it's all we have for now

I have cleaned and reassembled about twice FAN testing with 25% and lowering the temperature to 245 ° C, it did not work either. If the filament outside 2.85mm rather than 3.00mm, can I do something about it with the original stuff or will I need something extra?

Hahahaha. Oh, well, I've tried with 230, no fan, 110º temperature, 40 mm/s speed and 107% flow. And the filament is coming very, very, very slow... i don't even think that can call "coming". The feeder is doing his job. Even when i tried to feed it manual, stills going out very, very, very slow. Then, i changed to 250 with all the same settings, didn't work neither. Changed to 260 thinking of temperature sensor fail... didn't work neither. I cleaned the nozzle too, i don't know what else i can do with the original stuff of the printer.

Hello, guys. Hope you're all having a great day! I have an Ultimaker Original + which was working pretty well with PLA. I ended off a whole wheel of this filament. Now that I'm trying to print with ABS, it just doesn't work. I've tried changing temperature and cleaning the nozzle, but i can't make it work. It would be so nice if someone can help me, thank you so much!