[INSTALLING PT100 AMPLIFIER BOARD ON UM2?]

plugged in directly to TEMP 1...still getting error

do you have a link to this githut?

[INSTALLING PT100 AMPLIFIER BOARD ON UM2?]

Where should I buy a genuine board from then?

So, I plug the pt100 cable into the mainboard TEMP 1 input?

[INSTALLING PT100 AMPLIFIER BOARD ON UM2?]

It's the white UM2 mainboard bought from Aliexpress.com. It has the LCD ulticontroller too

[INSTALLING PT100 AMPLIFIER BOARD ON UM2?]

thanks...the instructions on the wiki above clearly state that you can't just plug it into the mainboard? The connector does fit the TEMP1 pin but I still get the same error message.

Also I can't upload the firmware for UM2 from Cura...but It will upload the UO firmware??

[INSTALLING PT100 AMPLIFIER BOARD ON UM2?]

Hi

Sorry, it's the new pt100 temperature sensor...'E3D V6 PT100 Total Upgrade Kit' from E3D-online. I am trying to install an e3dv6 hot end on the UM2 clone i'm building, and the um2 mainboard gives me a 'TEMP SENSOR ERROR message when I power it up. The kit comes with an amplifier board which is supposed to be connected to a 'spare analog input pin' on the mainboard. I have no idea how to change the firmware to enable it, although I think I have coneected it to the right pin selected

The um2 clone is an aluminium extrusion version...it has the white mainboard plus ultiLCD

[INSTALLING PT100 AMPLIFIER BOARD ON UM2?]

Hi all

Got the new pt100 sensor kit for my UM2 clone but not sure how to install on mainboard...any tips?

Thanks