UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
It was dropped for the moment as its implementation was horrible. If your standard frame is rotated by 90 degrees it's probably better not to use the lay flat in the first place but to simply rotate the object by the required amount.
"For the moment."
It doesn't matter if the implementation is horrible, because a horrible implementation is better than no implementation at all.
When I have an object whose flattest side is 14.7 degrees off from a major axis, then no other way lets me actually print it without some side/slice of it being bent or striated. The "shift rotate" only allows single-degree rotations, which is not enough to make even a one inch object lay flat within the margin of one layer.
Cura 15.06 - Lay Flat command?
in UltiMaker Cura
Posted
"For the moment."
It doesn't matter if the implementation is horrible, because a horrible implementation is better than no implementation at all.
When I have an object whose flattest side is 14.7 degrees off from a major axis, then no other way lets me actually print it without some side/slice of it being bent or striated. The "shift rotate" only allows single-degree rotations, which is not enough to make even a one inch object lay flat within the margin of one layer.