UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I tried the X/Y settings but didn´t get the proper results.
Similar to what you proposed, I added another very thin pad to the existing ones, jut to get the support under the model. I removed them after the print was done.
They were twice as long as the original ones and then it was OK.
How to enable support?
in UltiMaker Cura
Posted
Thanks for your answer.
I tried the X/Y settings but didn´t get the proper results.
Similar to what you proposed, I added another very thin pad to the existing ones, jut to get the support under the model. I removed them after the print was done.
They were twice as long as the original ones and then it was OK.