[Cura 2.3 Beta Awesomeness and Some Issues]

Well it isn't a bug. It can't fill a gap that isn't proportional to the nozzle line setting. You can force to overextrude by increasing the infill gap. Or just change the wall line size until it fits. Measure the distance between walls and split it by two or three, use that number for the walls and it should work.

 

That may be, but I don't think that's the case because I don't have that problem with 2.1 or Slic3r. Actually I've temporarily switched to Slic3r until 2.3 final is released because it is ruining my prints, it's way too weak where it doesn't fill. It's also not properly bonding the walls and the infill which is also different from 2.1.

update: I see that 2.3 final is in fact now released. I'll test it out and see if the issue is resolved.

[Cura 2.3 Beta is here!]

The v2.1.99 is the result of a bad build that was supposed to get pushed live. They commented on that in a different thread. I'm also having issues with infill and have yet to get a response.... I've switched to Slic3r for the time being as this results in unusable prints.

 

Just downloaded Cura 2.3 beta, when installing it reported it was installing Cura 2.1

Installed ok but will not start, shown the Curo loading window Version 2.1.99

then stops, Cura will not start.

using windows 10 x64, printer Ultimaker 2

Phil

 

[Cura 2.3 Beta Awesomeness and Some Issues]

bump

 

I have a bug where the slicer leaves out the infill on small features.

Update: I thought I'd add that the infill isn't bonding to the wall properly. It seems to be leaving a little gap. I can post up a picture of an actual print if necessary.

 

[Blue lines all over my models in Cura]

 

Do you have a picture of the finished model? What is your infill overlap setting? I believe the standard is 10%

 

Yeah, I haven't changed that value, so It's at 10 %. I believe this "bug" just happened all of a sudden, I've tried to delete Cura, and reinstalling It a couple of times, but It's still like this..

Here's a picture of the latest print: http://imgur.com/pjZOohu

Thank you

 

Are you using the beta cause a bad build went out and it's messed up.

[Blue lines all over my models in Cura]

Do you have a picture of the finished model? What is your infill overlap setting? I believe the standard is 10%

[Cura - No Infill Between Thin Walls?]

I have the same issue, I also posted in the 2.3 Beta Thread with pictures.

[Cura 2.3 Beta Awesomeness and Some Issues]

I have a bug where the slicer leaves out the infill on small features.

Update: I thought I'd add that the infill isn't bonding to the wall properly. It seems to be leaving a little gap. I can post up a picture of an actual print if necessary.