UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I have the same. It is the small wires rubbing. But i can get to them to secure them and now the top and left lights have gone out. Not very good for a brand new machine just out out of the box.
Cant i remove front or side panel to properly access? If not then this will have to go back :(
Removing Print Best Practices
in Improve your 3D prints
Posted
I have the same. It is the small wires rubbing. But i can get to them to secure them and now the top and left lights have gone out. Not very good for a brand new machine just out out of the box.
Cant i remove front or side panel to properly access? If not then this will have to go back :(