UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
does somebody has experianced this issue and is it a fault or within production tolerances?
My UM2 is just standing on three of its four corners, one corner is floating. I measured all casing parts and have found that the top piece does not have 90 degree angles, while the other parts have, so that the housing is slightly deformed my results in the um just standing on three feets. the floating edge has around 2-3mm spacing.
UM2 Top Casing Faulty / Corner floating
in UltiMaker 3D printers
Posted
Hello friends,
does somebody has experianced this issue and is it a fault or within production tolerances?
My UM2 is just standing on three of its four corners, one corner is floating. I measured all casing parts and have found that the top piece does not have 90 degree angles, while the other parts have, so that the housing is slightly deformed my results in the um just standing on three feets. the floating edge has around 2-3mm spacing.
With best regards
Nnead