[Support settings for Cura with UM 3 Extended]

Just an example of the difference between Cura and Catalyst

I will make a sketch of other issue

[Support settings for Cura with UM 3 Extended]

Hi all.

I have some experience from printing with Stratasys (yPrint SE +).

On this printer with the Catalyst Software the support builds upwards in an angle for overhang, in about 60'degrees from the print surface below. On my newly investment of UM3 Extended, the supports builds 90'degrees upwards, and I feel there is built a lot of un-necessary support.

Is there a way to change the settings for this? Of course the build structure for support can be reduced, but I guess there should be an option in Cura to let the supports to build in another way, like the way it's built in Catalyst for Stratasys....

Hope someone understand the issue