UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I am totally new to Ultimaker printers and just bought and installed an Ultimaker 3. I installed the BB core in the second slot and noticed that the BB core nozzle is sticking out a little bit more than the AA core nozzle. The cores are identified correctly and they seem installed correctly as well if I compare it to internet images.
If I start a XY calibration though, I see the BB core nozzle touching the bed and the AA core nozzle starts printing with an offset from the bed of about a millimeter. Shouldn't the BB core be retracted so that the AA core nozzle is lower than the BB core nozzle?
BB core nozzle touching bed
in UltiMaker 3D printers
Posted · Edited by Guest
Hi everyone,
I am totally new to Ultimaker printers and just bought and installed an Ultimaker 3. I installed the BB core in the second slot and noticed that the BB core nozzle is sticking out a little bit more than the AA core nozzle. The cores are identified correctly and they seem installed correctly as well if I compare it to internet images.
If I start a XY calibration though, I see the BB core nozzle touching the bed and the AA core nozzle starts printing with an offset from the bed of about a millimeter. Shouldn't the BB core be retracted so that the AA core nozzle is lower than the BB core nozzle?
Help is much appreciated!