robrien24
-
Posts
2 -
Joined
-
Last visited
Content Type
Forums
Events
3D Prints
Posts posted by robrien24
-
-
I have a model with (3) different surfaces that could be considered as "top", but CURA 2.5 only seems to fully recognize one of them. That surface prints well, but the others do not. This is visible in the layer view and leaves gaps in the printed model that are problematic. The image below compares the CURA image with the actual print. The broad yellow layer seems to be the top while the other 'tops' are mostly ignored...very little yellow.
Any ideas how to get a complete fill on the surfaces showing gaps?
Top Layer Fill Problem
in UltiMaker 3D printers
Posted
I edited the original post to include the photo. Is this correct or should I re-post?