KrisR
-
Posts
2 -
Joined
Content Type
Forums
Events
3D Prints
Posts posted by KrisR
-
-
After some 20--30 minutes the printer just stopped. The nozzle was not moving. Display showed only info about remaining time.
I tried to pause and restart the job -- nothing happened.
After cancelling, the printer didn't drowe any axis. eventually it displayed error ER16, which is for Z-axis limiting.
I drowe the axis manually and could hear the "click" nicely and clear.
Just to be sure I cleaned and lubricated z-axis. 2 days later the same error.
Any ideas how to search for the reason of this error?
best regards
UM3 with firmware 5.2.16.202000331
XY motion stress-test - OK
bed level sensor performance - OK
switches - OK
UM3 stoped mid in the print, then ER16
in UltiMaker 3D printers
Posted
er16 came in 1/3--1/2 of the print. (and it wasn't any big -- just two tubes d32x2x18)
If you are right about 24V -- where should I measure it? I have mutlimeter somewhere around. Before I start to break things apart it would be nice to check it.